Service manual 2006 keeway focus matrix 125 150 scooter. service manual 2006 keeway focus matrix himaswitch.com download 2019-03-16

Service manual 2006 keeway focus matrix 125 150 scooter Rating: 7,1/10 1302 reviews

service manual 2006 keeway focus matrix himaswitch.com download

service manual 2006 keeway focus matrix 125 150 scooter

Close the bleeder vavle, disconnect the pipe. Measure the piston ring free end gap to check the spring tension. When the turn signal switch is turned on and the turn signal light flashes,the turn signal indicator light oil level check light also flashes,both being not concurrently but alternatively as one being. Two inspection checks must be performed to thoroughly check the operation of the drivetrain. Faulty neutral, clutch lever, or kickstand safety switch. Bleed air from the bleeder valve.

Next

Keeway focus matrix servicemanual

service manual 2006 keeway focus matrix 125 150 scooter

For each weight, approximately 1. Disassemble the movable drive face. Starter motor removal and disassembly Remove the starter motor Disassemble the starter motor as shown in the illustration. Float is not working properly. Never use cleaning solvent or gasoline to wash them.

Next

REPAIR Manual 2006 Keeway F

service manual 2006 keeway focus matrix 125 150 scooter

If you prefer a printed version of the Manual for keeway 125 - free pdf ebook downloads Download free pdf files,ebooks and documents of manual for keeway 125. When th scooter is not used for more than 1 month especially dring the winter season , recharge the battery once a month at least. Turn the throttle grip full open. Remove side cover Remove movable ratchet wheel and clip. Brake shoe wear The vehicle is equipped with the brake lining limit Indicator on the rear brake. Defective starter pinion gears 6.

Next

20 Most Recent 2006 Keeway Focus125 Questions & Answers

service manual 2006 keeway focus matrix 125 150 scooter

The end gap of each ring is to be measued with the ring fitted squarely into the cylidner bore and held at the least worn part near the cylidner bottom, as shown in the illustration. Therefore, the jet should not be replaced with a size other than the original. Sucking air from intake pipe. Gas leaks from the joint in crankcase, cylinder or cylinder Repair or replace. Gasoline is a highly volatile chemical, and should be treated with care. Install the right left suspension arms. Therefore, force can be amplified and carried through fluids by application of force to surface in a sealed system.

Next

2006 Keeway ARN 125 , 150 Scooter Service Manual

service manual 2006 keeway focus matrix 125 150 scooter

Oil leakage of shock absorber, Replace. Considering the danger to which such trapped air exposes the machine and rider, it is essential that, after remounting the brake and restoring the brake system to the normal condition, the brake fluid circuit be purged of air in the following manner: Fill up the master cyliner reservoir to the upper end of the inspection window. Hi, Callum and the usual suspects are: 1. Stiff piston ring in place. Driving face spring Measure the free distance of the driven face spring.

Next

REPAIR Manual 2006 Keeway F

service manual 2006 keeway focus matrix 125 150 scooter

The fuel meter is normal if its pointer indicates the E empty position when the specified voltage is applied to the circuit and if its pointer indicates the F full position when the resistor is changed to 10 ohms. Ensure proper fit and free movement of all gears and pinions. Take precaution not to allow any of the fluid to spill. Lightly coat oil seal with oil when installing, and ensure proper direction and fit. This repair service manual gives technical repair information of every part of the 2006 Keeway F-act Matrix 50 Scooter. Electronic tester Ignition coil testing lead Use portable tester to check it.

Next

KEEWAY FOCUS MAINTENANCE MANUAL Pdf Download.

service manual 2006 keeway focus matrix 125 150 scooter

After recharging, wait for more than 30 minutes and apply multimeter to measure the battery voltage. View online or free download from eBooks-go. Never reuse the brake fluid left over from the last servicing and stored for long periods. Therefore, the jet should not be replaced with a size other than the original. An excessive runout is usually due to worn or loose wheel bearings and can be reduced by replacing the bearings. Start maintaining or rebuilding your Scooter by yourself without paying anyone a dime.

Next

20 Most Recent 2006 Keeway Focus125 Questions & Answers

service manual 2006 keeway focus matrix 125 150 scooter

Inspect each rubber part for damage and wear. Caution Oil pump calbe adjustment must be done after throttle cable adjustment. Clogged return port of master cylinder. If the marks are not aligned, loosen lock nuts and turn the adjuster in or out to align the marks. Check throttle valve for operation.

Next