For protection against static electricity discharge to the printer's internal electronics through the interface connector s , cover any interface connector that is not in use with the protective cap supplied. Exit all active software applications. If an information notification event occurs, the 3D view and an alert sound are used to notify you. Do not touch parts in this area, because there is a danger of. Insert the correct memory card. The password does not match the password set. The locations where paper jams might occur are also shown here, with each location explained in the table below.
For details refer to Advanced Operation Guide. Note the replacement is not always necessary at this stage. Push down on the top of the toner container to install it firmly in place. For example, if you do not want fonts installed on your computer to be replaced, select Custom Mode and deselect the Fonts checkbox in the installation window. . Always on top Positions the Status Monitor in front of other active windows.
Open the printer top cover top tray and check that the toner containers are correctly installed in the printer. For more information, refer to Paper Jam in Printer on page 4-14. Conduct color calibration either by switching the printer off then on or using the printer operation panel. This completes the printer setup procedure. We will not be liable for any damage caused by the use of third party supplies in this machine.
Then, turn on the printer. All the printers installed in Windows are listed. Sound Notification Tab The Sound Notification tab contains the following items. When replacing the toner container of any color, always replace the waste toner box at the same time. Remove the jammed paper using the procedure given below. Next, specify the print settings. If Status Monitor startup is requested from multiple printers, Status Monitors are launched for each printer that issues the request.
Paper Jam at Cassette 2 to 4 Paper is jammed at the paper cassette. Avoid locations near a window or with exposure to direct sunlight. For more information, refer to Memory Card Using the memory card section of the Advanced Operation Guide. For details, refer to Color Calibration section of the Advanced Operation Guide. Click the drop down list of printer names.
Copying or other reproduction of all or part of this guide, any copyrightable subject matter without the prior written consent of Kyocera Mita Corporation is prohibited. A new waste toner box is included with the toner kit. Safety Instructions Regarding the Disconnection of Power. For more information on installing the toner containers, refer to Toner Container Replacement on page 3-2. It should also be cleaned if streaking or lines appear on printed copies, or if printouts appear faint or blurred.
Other Precautions Connect the power plug to the closest outlet possible to the printer. If this box is full, the printer may be damaged or contaminated by the waste toner that may spill over the box. This will be the name displayed in the Printer window and in the printer lists displayed in applications. NetWare This section explains the procedure for enabling NetWare. Use Number of copies to enter the number of prints required. There is no need for customers to use this menu. Transparency Displays the Status Monitor as a transparent window.
Set the new toner container in the printer as shown in the figure below. There is no need for customers to use this menu. Paper jams can occur in more than one component on the paper paths. Then, if AppleTalk is set to Off, use to select On. The Print dialog box displays. After replacing the toner containers and the waste toner box, clean the paper transfer unit. Click the name of the machine.
Chapter 4 - Troubleshooting This chapter explains how to handle printer problems that may occur, such as paper jams. First, open the printer's front cover and check for paper jams in the paper transfer unit. This guide, any copyrightable subject matter sold or provided with or in connection with the sale of the page printer, are protected by copyright. Paper Transfer Unit Duplex Unit Paper Ramp Note Be careful not to touch the black transfer roller and black transfer belt during cleaning as this may adversely affect print quality. Conduct color calibration either by switching the printer off then on or using the printer operation panel. Specify whether to share the print system name or set the print system as an existing printer and then click Next. You can choose whether to show or hide the 3D view from the menu displayed when you right-click the Status Monitor icon.