Riding on paved surfaces can cause loss of control. When inspecting the battery, be sure the breather hose is routed correctly. This information will be needed to order spare parts from your Yamaha dealer. Remove the differential gear case cover. Differential gear oil drain bolt ferential gear case. Move in direction b to turn off the starter choke.
Riding on public roads can result in collisions with other vehicles. To prevent burns, avoid touching the exhaust system. The tires listed below have been ap- distilled water if refilling is necessary. Move in direction a to turn on the starter choke. See Manual for correct tightening torque.
Dismount on the uphill side or to a side if pointed straight uphill. Remove the screws holding the headlight unit assembly to the headlight body. A collision or rollover can occur quickly, even during routine maneuvers such as turning and riding on hills or over obstacles, if you fail to take proper precautions. Make sure the brakes are not spongy. Remove the air filter element from the 5. Rear brake cable locknut 2.
Final gear case cover 2. Wash the air filter element gently but frame. If the battery is to be stored for a longer period than the above, check the specific gravity at least once a month and re- charge the battery when it is too low. You could a caution flag on the machine. Make sure that this area 1st gear position and then release the parking is free of obstacles and other riders. Consult a Yamaha dealer if you 1.
Warm up the engine for several minutes at idle speed. Your Yamaha dealer has a variety of accessories. Stay alert for holes, rocks, or roots in the terrain, and oth- er hidden hazards which may cause the ma- chine to upset. See proved by Yamaha Motor Co. It is recommended that these items be serviced by a Yamaha dealer.
Check behind you for people or obsta- the throttle lever to its closed position. Warm up the engine for several minutes, 5. Place the machine on a level surface. All the torque settings and adjust them as neces- parts and accessories added to this ve- sary. Turn the adjusting bolt counterclockwise to 2. Slowly turn the adjusting bolt counter- decrease the clutch free play and turn it clock- clockwise until resistance is felt.
Remove the screws holding the headlight unit assembly to the headlight body. Install the nut with its tapered side towards the wheel. Before riding, check that the brake fluid is above the minimum level mark and replenish if necessary. Do not turn at excessive speed. Take the machine Make sure the differential gear oil is at the to a Yamaha dealer or refer to the Service specified level.
It is not acceptable proof of maintenance work. It should be cleaned and lubri- 8. The fuel cock has three positions. Remove the bulb holder cover. This would and drive train may result. Pull it toward the handlebar to ap- ply the front brake. Look out for obstacles which could Improperly operating over obstacles.