Warm up the engine for a few minutes according to the flushing procedure. F0M0045 Approval label of Emission control cer- tificate This label is attached to the electrical box. So visit your authorized Yamaha dealer to get all the facts. When adding the battery fluid or recharg- ing, be sure to bring it out of the battery compartment. The exceptions to this the other vessel is expected to maintain are: its course and speed. A helmet could catch the always perform pre-operation water during a fall into the water. Check the ground line of the starter relay switch.
Apply engine oil to the O-ring and threads of a new oil filter cartridge and install the filter using the filter wrench. Removal Pull the front seat latch levers up, then lift the rear of the seat , and pull back. When transporting the water vehicle on a trailer, lock the bow with a pin to the trail- er and secure the stern with ropes or tie downs through the rope hole s on the. They can sponta- neously ignite. Spray the lubricant to the maintenance joint threads and the O-ring.
If this happens during opera- tion, beach the vehicle. If you do not see any water at the outlet s , cooling water may not be circulating in the engine. Continuing to operate at higher speeds could result in severe engine damage. I'll never leave you digging through hundreds or even thousands of pages to find what you need. He can show you how easy it is to protect your investment with Yamaha Extended Service.
It should be smooth over the com- plete range, and spring back to the idle position on its own when released. Tighten the spark plug to the specified torque. Spray the lubricant into joint hole for 3 seconds. All of the manual listed below are full factory service manuals with hundreds of pages containing step by step instructions, full wiring diagrams and detailed illustrations and photos on how to repair, rebuild or maintain virtually anything to your Yamaha Waverunner. Remove the joint hoses from the clip s and disconnect the maintenance joint. It is stopped by water resistance when the throttle lever is released. This floor when the vehicle is in motion.
The fatigue and exposure that could result after unsuccessful attempts to get back on the vehicle may increase the risk of injuries and drowning. Also, check that the clamp is installed on the oil tank securely. Check that water comes out of the outlet s while the engine is running. If the clearance is out of specification, disassemble and inspect the impeller and impeller housing area. Disconnect the ignition coil connectors. When the oil tank need to be cleaned, or when any water or dirt is found in the oil tank, take the water vehicle to your Yamaha dealer for service.
Install the joint hoses into the clip s properly. If the settings are disturbed without having technical knowledge, poor engine performance and damage may result. The spark plug cap and ignition coil are integrated. Impeller clearance is critical for proper performance. No one has time to wait for a book or cd in the mail while their vehicle is down and if you're a mechanic your customer definitely doesn't wait a week for the manual to arrive. Check the insulator for cracks or damage, and the electrodes for wear, fouling or discoloration. Not all manuals are the same I have spent years setting up my manuals to ensure they are the best available anywhere on the internet.
The trim angle of your water vehicle can be adjusted by operating the Q. Wear- skills acquired only through practice ing gloves can also help protect hands over a period of time. When the throttle lever is released, it returns to its closed idle position through the action of a return spring. Slide the latch to open the lid. Secure the watercraft on a stand or trailer. Electrical box Fuel filter Contains most electrical components, Prevents dust contained in fuel from getting included fuse in this water resistant box.
A thor- importance is distinguished in the follow-. If the vehicle must be towed in an emer- gency using a tow rope, the operator should ride the vehicle, holding onto the handlebars. If you do not have one, contact your local Yamaha Water Vehicle dealer or a fire extinguisher dealer to obtain one meeting the proper specifi- cations. Check that the throttle opens and automatically closes in all steering positions. The exceptions to this the other vessel is expected to maintain are: its course and speed. Remove the bolts and the direct ignition coils. Is the ground line normal? Leave the engine off, or operate only at trolling speeds, for 10 minutes after the vehicle has been put right-side up.